Rules
After 4 feature wins, motor will be torn down by track.
If legal, will be give $50 for the gaskets. If not legal, driver will lose all points for the season and the money that
night. $300 FINE.
Any American coupe or sedan. Stock production
frame with minimum 101" wheelbase. Body may not be shortened, sectioned or have chopped tops. MUST REMAIN STOCK
APPEARING. After market body okay. No homemade bodies, No wedge bodies. Stock fire wall, floor pan must
extend to rear of drivers seat. Floor pan must cover transmission. Frame must remian stock. Fenders may
be trimmed to allow tire clearance. Sub-frame cars may be tied together under car. Front and rear bumpers in stock
position required and must be rounded off Must have hook chains front and rear. Nose and grill may be replaced
with plastic. Nerf bars not to exeed one (1) ince from body and maximum 1 1/2 diameter. FUEL CELL IS MANDATORY.
No boat tanks or homemade gas containers are allowed. Trunk flooring may be removed to mount cell. Fuel cells
must be contained in a reinforced steel container and securely mounted. vent tube must be below the bottom of cell or
roll over valve inline. Battery may be relocated, bu no in deiver compartment and be securely mounted. Doors must
be welded shut. All glass and flammable materical must be removed. Cars must have a MINIMUM 6 point roll cage
1 1/2 inch minimum diameter pipe, securly welded to frame, Three (3) divers side window bars required. NO BLACK or galvanized
pipe allowed. After market pedals will be allowed as long as brakes are not adjustable.
Suspension;
Stock type suspension in stock location. No weight
jacks, or wedge block. Front shocks must bein stock location, Rear shocks may be relocated if needed
and only 1 shock per wheel. Lowering will be allowed. Right front safety hub is optional. No sliders, adjustable
shackles are allowed on rear of rear leaf springs. Quick steer allowed. No chrysler springs allowed
except on chrysler cars. Engines is set back left front spark plug hole can be no farther back than center of the upper
ball joint. Brake adjusters are allowed.
Rear Ends;
Rear end must be locked and posi trac. 9 inch
ford rear end permitted. Rear disc brakes permitted must be stock calipers. No 3/4 ton truck rear ends.
Transmissions;
Stock manual or stock automatic with stock torque converter.
Stock flywheel clutch and pressure plate. No aluminum flywheels. No aluminum drive shafts. Drive shaft loop
required. Drive shaft must be painted white.
Weight;
Car must weigh 3200lbs with driver after race.
Top 5 cars must weight after each heat and feature race.
Tires;
Track tires, asphalt scuffed take offs, (no rew tires) 50
or harder compund. Cross groovign allowed. 8 or 10 inch steel wheels. 8 or 10 inch bead lock allowed on
right front and right rear only. 1 inch lug nuts MANDATORY.
Fuel;
Racing gas permitted. No nitrous oxide or alchol.
Engines;
362 cubic inch MAXIMUM motor to be stock GM to GM, Ford
to Ford, etc. Stock production cast iron heads only, No porting or polishing Vortes heads and stock vortex intakes
allowed. Screw-in-studs and guide plates allowed. After market camshafts are allowed. No rollers.
Must pull 15 inches of vacuum at 1000rpm vacuum to be pulled from base of carburetor or intake. Top 5 cars will be checked
after feature race. 12 volt hookup for track tack required. All engines must be turned off after vacuum test flat
top or dished pistons only. Two valve relief piston allowed. Stock rods (after market rod bolts okay). Stock
crank. after market stock crank okay. NO lightening or nife edging. Stock Hei or point distributor, no supercoils
or magnetics or msd. Cast iron intake only, 2 or 4 barrel okay. No polishing. Carburetors spacer not exceeding
2 inches in height. Mechanical fuel pump in stock location. Stock manual fuel pump. No electric or belt
driven pumps. Header and exhaust manifolds allowed. NO 180 degree headers. Carbureator can be no larger
than holley 500 cfm 2 barrel and must pass inspection from top side with guage. (must be stock ventrue 1 3/8 inch)
Choke horn may be removed.
